PRODUCT SPECIFICATIONS
ACTUATORS QTH SERIES
Double-acting QTH Series actuators are available with individual test and guaranteed minimum output torque ranging from 1,800 Nm (15,900 lb-in) to 180,000 Nm (1,593,000 lb-in).
Our single acting QTH Series actuators produce spring ending torque ranging from 1,350 Nm (11,950 lb-in) to 60,750 Nm (537,650 lb-in). Further torque ranges available on request.
The hydraulic operating pressure for the QTH Series ranges between 20 barg (290 psig) to 350 barg (5,000 psig).
Standart design construction allows operating temperature from -30 degC (-22 degF) to +93 degC (+199 degF).
Low temperature design extends operating range down to -60 degC (-76 degF).
Supply Medium:
Hydraulic oil mineral based (standard). Special versions are available for fire-resistant or water based fluids.
CONTROLS SYSTEM
Actuator Control Systems are integral part of any automated valve package. Our QTH Series actuators can be equipped with extensive range of auxiliary components specifically engineered and integrated to meet the largest variety of Customers' requests either for ON/OFF or modulating. Our Control System can be housed within cabinet &/or stainless steel (AISI316) panel folded over to provide sun-shade, and assembled on actuator or at remote location.
We have already pre-engineered different solutions to meet the most commonly required control systems. These solutions, based on standard components, offer reduced lead time, simplified purchasing, commissioning and start-up activities. Please contact with us for any additional detail.
Position Monitor Device:
Virtually all positioning monitor devices can be assembled on top of our QTH Series actuators, responding to any kind of technical requirement.
-
Quarter turn Scotch Yoke mechanism
-
Double Acting / Single Acting
-
Symmetric or canted yoke design
-
Hydraulic power supply (up to 350 BARG)
-
Output torque up to 800.000 Nm
-
Standard temperature range -20°C +85°C
-
Low temperature version -60°C + 85°C
-
PED 97/23/EC Compliant
-
ATEX 94/9/EC Compliant
-
IP67M, NEMA 4, 4x & 6
-
SIL3 Certified IEC 61508
-
Corrosion resistant cylinder
-
Manual override available
-
Protected travel stops are standard
-
Modular concept
-
Actuator in carbon steel - NO Aluminum NO Cast Iron
-
Cylinder barrel, end flanges, tie-rods, nuts and power springs to EN10204