PRODUCT SPECIFICATIONS
ACTUATORS BYP SERIES
Three off actuator center-body size available. Double-acting BYP Series are available with individual test and guaranteed minimum output torque ranging from 40 Nm (350 lb-ib) to 7,500 Nm (66,375 ln-in).
Our single acting BYP series requires pressure in onyl one stroking direction and they are available both for fail clockwise and counterclockwise application by simply reversing actuator mounting plane. These models produce spring ending torque ranging from 31 Nm (275 lb-in) to 2,080 Nm (21,080 lb-in).
The pneumatic operating pressure for the BYP Series ranges between 2 barg (30 psig) and 12 barg (175 psig).
Their standard design construction allows operating temperature from -30 degC (-22 degF) to +93 degC (+199 degF).
Low temperature extended operating range down to +60 degC (+76 degF).
CONTROL SYSTEM
Actuator Control Systems are integral part of any automated valve package. Our BYP Series actuators can be equipped with extensive range of auxiliary components specifically engineered and integrated to meet the largest variety of Customers' requests either for ON/OFF or modulating. Our Control System can be housed within cabinet &/or stainless steel (AISI316) panel folded over to provide sun-shade, and assembled on actuator or at remote location.
Position Monitor Device:
Virtually all positioning monitor devices can be assembled on top of our BYP Series actuators, responding to any kind of technical requirement.
-
Quarter turn SCOTCH YOKE mechanism
-
Double Acting / Single Acting
-
Symmetric or canted yoke design
-
Pneumatic power supply (up to 12 BARG)
-
Output torque up to 10.000 Nm
-
Standard temperature range -20°C +85°C
-
Low temperature version -60°C + 85°C
-
PED 97/23/EC Compliant
-
ATEX 94/9/EC Compliant
-
IP67M, NEMA 4, 4x & 6
-
SIL3 Certified IEC 61508
-
Corrosion resistant cylinder
-
Manual override available
-
Protected travel stops are standard
-
Modular concept
-
Actuator in carbon steel - NO Aluminum NO Cast Iron
-
Cylinder barrel, end flanges, tie-rods, nuts and power springs to EN10204 3.1